09.05.23 -- Don't Miss Our Favorite Products For September

The Qorvo QPC2108 is a packaged 6-bit digital phase shifter fabricated on Qorvo's high-performance 0.15 um GaAs pHEMT process.  It operates over 2.5 - 4 GHz while providing 360 degrees phase coverage with an LSB of 5.625.

The AMP4065-LCP1 solid-state high-power amplifier operates within a wide frequency range of 18.0 - 26.5 GHz with a power output exceeding 60 watts in CW mode and a minimum of 40 watts (typical: 50 watts) at P1dB.

Wilkinson dividers with 3 dB per split using our advanced dielectric materials for compactness and temperature stability. These devices feature integrated thin film resistors and are available for both SMT and chip-and-wire hybrid assembly.

The Model 800W1000 is a solid-state, Class A design, self-contained, air-cooled, broadband power amplifier designed for applications where instantaneous bandwidth, high gain, and linearity are required.

The R&S FE170ST and R&S FE170SR are the perfect solutions for early sub-terahertz and 6G research activities. Choose the FE170ST for signal generation and the FE170SR for signal analysis.

Wireless InSite offers ray-tracing models and EM solvers to analyze site-specific radio wave propagation. The software accurately predicts channel features in urban, indoor, rural, and mixed path settings.

The ultra-miniature, lightweight transponder is designed for use as a tracking radar enhancement device in airborne applications such as missiles, unmanned air vehicles, or manned aircraft operating at instrumented ranges.

This A.H. Systems passive loop antenna features a balanced Faraday shield for precise magnetic field measurements, enhanced by its electrostatic shield that reduces E-field interference.

The KMW2040-LTE is an RF power amplifier module for OEM applications featuring a break between stages for insertion of customer BP filters, a forward power monitor, and a heatsink temperature monitor.

The SPDT externally terminated RF switch with 2.92 mm female connectors is available in the failsafe, latching, or momentary (normally open) configuration.

Model 50BA-057-95 is a 50 Ohm benchtop attenuator assembly containing two solid-state step attenuators with a range of 0 to 95dB by 1dB steps and operates from 200 MHz to 7125 MHz.

KRYTAR Bias Tees are the ideal choice for powering remote control of pre-amplifiers or low-noise amplifiers (LNAs) in antennas, controlling remote DC signals and testing of many RF applications. 

The SKY53746-11 is a diversity receive module and is scalable to support two CA MIMO regional and roaming band requirements. The SKY53746-11 is part of our Sky5 product portfolio. 

The NBS-Series consists of calibration standards based on the primary fundamental physics constants of thermal noise and blackbody radiation. 

The EBAL-0026 is a broadband balun, hand-tuned for optimal phase and amplitude balance over a 10 MHz to 26 GHz bandwidth.

The AMP2055DB-200-1LC solid-state high power amplifier operates in the 20 to 6,000 MHz range and is designed to excel in a range of applications including broadband EMI/RFI, Lab, GTEM, and IEC testing.