AD300A: PTFE/Woven Fiberglass/Micro-Ceramic Filled Laminate
•Datasheet: AD300A - PTFE/Woven Fiberglass/Micro-Ceramic Filled Laminate
•Microwave And RF Materials Guide
AD300A is a woven fiberglass reinforced PTFE/Microfine Ceramic composite material and is a significant improvement in cost/performance over traditional fluoropolymer- glass laminates. This combination offers designers an advantage for improving electrical performance through the use of advanced material without the additional cost traditionally associated with higher performance.
AD300A was specifically developed for Base Station Antennas and Base Station Power Amplifiers where low loss and low PIM is critical. Other key performance attributes include low moisture absorption, low thermal coefficient of the dielectic (CTEr), high copper peel strength and good dimensional and thermal stability. The 3.00 Dielectric Constant also provides a small degree of miniaturization that is critical to the size constraints of some antenna designs.
AD300A is compatible with the processing used for standard PTFE based printed circuit board substrates. In addition, the low Z-axis thermal expansion provided by the ceramic loading, will improve plated through hole reliability compared to typical PTFE based laminates.
|
Next
Generation of Lower Loss Materials, Available with PIM Technology;
Not Available below 0.020". |
||||
|
Typical
thicknesses include 0.030", 0.031", 0.040", 0.060",
and 0.062". Inquire for
thicker laminates. |
||||
|
2.55 |
0.0015 |
N/A |
||
|
2.60 |
0.0017 |
N/A |
||
|
3.00 |
0.0020 |
/09 |
||
|
3.20 |
0.0032 |
/09 |
||
Features:
- Cost-Effective Construction using a PTFE and Microfine Ceramic Resin
- High Volume Manufacturing Design
- Excellent PIM Performance
- Reduced Thermal Coefficient of Dielectric Constant (TCer)
- High Thermal Conductivity ideal for Higher Power Designs
Click Here To Download:
•Datasheet: AD300A - PTFE/Woven Fiberglass/Micro-Ceramic Filled Laminate
•Microwave And RF Materials Guide